DAVIS DriveRight OBD II Instalační příručka

Procházejte online nebo si stáhněte Instalační příručka pro Elektronika motorových vozidel DAVIS DriveRight OBD II. DAVIS DriveRight OBD II Installation guide Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 16
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
DriveRight OBDII Installation Guide
Zobrazit stránku 0
1 2 3 4 5 6 ... 15 16

Shrnutí obsahu

Strany 1

DriveRight OBDII Installation Guide

Strany 2 - FOR HOME OR OFFICE USE

8Top of Dashboard Mounting Using Brackets or Velcro™Sun Visor Mounting 2. Insert the battery into the DriveRight console.Pan Head Self-Tapping ScrewSp

Strany 3 - Introduction

93. Connect the DriveRight console cable to the adapter cable. Note: To disconnect the cables, hold the both cables by the connector housing and pull

Strany 4 - All Installations

10Appendix 1: OBDII Compatibility Use this list to verify the compatibility of your vehicle’s OBDII port with DriveRight OBD.Supported OBDII Protocols

Strany 5

11Technical SupportIf you are experiencing problems with your DriveRight, first check the cable connections and verify the calibration settings. If yo

Strany 6 - OBDII Port

12Installation Notes:

Strany 7 - Indicator Light

13Installation Notes:

Strany 8

14Installation Notes:

Strany 9 - Hold as Shown Here

FCC Part 15 Class B Registration WarningThis equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to P

Strany 10 - Sun Visor Mounting

1IntroductionThis manual provides instructions and information necessary to install the OBD version of the DriveRight 600E device. The DriveRight OBD

Strany 11 - Sliding Connector

2CablesWiring ComponentsAdditional DriveRight DocumentationRefer to the following documents for information on configuring and using your DriveRight:•

Strany 12

3Installations using Adapter Cable Digital InputsIf you are using the adapter cable digital inputs in your installation, the following additional tool

Strany 13 - Technical Support

4Wiring DiagramThe diagram below is an example of DriveRight OBD wiring. Procedure 1: Connect OBD Cable to OBDII Port.1. Locate the OBDII port in the

Strany 14 - Installation Notes:

5Look in the follow areas if you have trouble finding the OBDII port: • Under the dash• In front of the passenger seat• Behind the ash tray• Behind a

Strany 15

61. If you are installing a DriveRight 600E OBD but not using the digital inputs, go to Step 10 of this procedure.2. Butt splice the red fuse holder t

Strany 16

77. Use the in-line butt splices to connect the blue wires with fuses to the Green (Digital Input 1) and Yellow (Digital Input 2) wires from the adapt

Komentáře k této Příručce

Žádné komentáře