Davis Universal Anemometer Interface for Vantage Pro2 Uživatelský manuál stáhnout pdf (Strana 7)

Connect the Anemometer Cable to the Interface

3-Volt Lithium Battery

“OUT”

RJ Jack

Anemometer

Selector Jumper

(labeled “P2”)

IN OUT

Solar Panel Cable

Square Black

Grommets

Cable Clamp

Mount

ISS Cable

Cable Clamp

Anemometer

Cable

“IN”

RJ Jack

1. Opentheinterfaceshelter.Feedthelooseendofthe6‐conductoranemometer

cableupthroughthesquareblackgrommetatthebaseoftheshelter.(The

Davisshelterhastwoofthesegrommetstoprovideweather‐resistant

entrancesforcables.Inthiscase,usethegrommetontheright.Youcanalso

rem

ovethegrommet,threadthecablethroughitandthenreplacethe

grommetintheshelterifthatiseasier.)

2. PlugtheendofthecableintotheRJja

cklabeled“IN.”

3. Locatetheanemome

terselectorjumperandmovetheshunttothecorrect

pins,asillustrated

•ShuntP2pins1&2ifyouranemometer’sAC

outputsignalhasafrequencyof90Hzwhen

thewindspeedis19.7mphor8.8m/s;

transferfunct

ion:mph=Hzx0.219.(e.g.

R.M.Yo

ung05103).

R.M. Young

(Pins 1 & 2 shunted)

Other

(Pins 2 & 3 shunted)



•ShuntP2pins2&3ifyo

uareusinganother

anemometerthatisnotanR.M.Youngor

doesnothavethesametransferfunctionas

theR.M.Young(seeabove).

1 2 3 4 5 6 7 8 9 10 11 12

Komentáře k této Příručce

Žádné komentáře

Davis Universal Anemometer Interface for Vantage Pro2 Uživatelský manuál Strana 7

Komentáře k této Příručce

Související produkty a manuály pro Teploměry Davis Universal Anemometer Interface for Vantage Pro2