Davis Vantage Pro2/Pro2 Plus: Temperature/Humidity Stati Uživatelský manuál Strana 1

1Wireless Temperature/Humidity Station Installation ManualFor Vantage Pro2™ and Vantage Pro2 Plus™The Wireless Temperature/Humidity Station, referred

10Maintenance• The ability of the radiation shield to keep fresh air flowing over the sensors will be reduced if the shield plates become dirty. Clean

11SpecificationsGeneralOperating Temperature . . . . . . . . . . . . . . . . . . . . . . -40° to +150° F (-40° to +65° C)Non-operating Temperature .

Product Numbers: 6382, 6382OVDavis Instruments Part Number: 07395.242Wireless Temperature/Humidity Station Installation Manual Rev. B Manual, 12/28/09

2Tools for SetupIn addition to the hardware provided, you will need some or all of the following materials: • Small phillips head screwdriver• Adjusta

33. When the screws are completely loos-ened, lift the mounting bracket away from the radiation shield.4. Rotate the mounting bracket and replace it o

42. Plug the Temp/Hum Sensor Cable into the jack labeled TEMP/HUM on the bot-tom right hand corner of the SIM board. Take care to carefully dress the

5DIP Switches in Top-right Corner of SIM (Illustration has been enlarged for clarity)Setting Console Station ID on the Console1. Put your console into

6This confirms communication between your Temp/Hum Station and the console. If you are not receiving the sensor readings on the console go the the nex

7Choosing a Location for the Temp/Hum StationConsider the following factors as you choose a location:• Do not mount the station near any source of col

8Tighten all four sets of washers and hex nuts until the mounting bracket is firmly mounted on the pole.3. Next, install the SIM Shelter. While holdin

92. Next, install the SIM Shelter. With a 3/16" (5 mm) drill bit, drill two holes approxi-mately 2" (50 mm) apart. Use a carpenter’s level t