Davis Wireless Temperature Station (6372) Installation M Uživatelský manuál

1Wireless Temperature StationInstallation ManualNote: The Wireless Temperature Station (Davis product number 6372) can be used with wireless Vantage

10A Note on Securing CablesTo prevent fraying or cutting of cables, secure them so they will not whip about in the wind. Secure a cable to a metal pol

11SpecificationsGeneralOperating Temperature . . . . . . . . . . . . . -40° to +150°F (-40° to +65°C)Non-operating Temperature . . . . . . . . . -50°

Product Numbers: 6372, 6372OVWireless Temperature Station Installation Manual 07395.239 Rev. D (3/8/13) ©2011 Davis Instruments Corp. All rights reser

2Installation StepsFor ease of installation, please follow steps in the order presented. • Prepare the temperature station, page 3• Insert the battery

3Preparing the Temperature StationThe illustration below shows the Sensor Interface Module, or “SIM”, inside the shelter.Insert the 3-volt lithium bat

4Note: The transmitter and receiver communicate with each other only when both are set to the same ID. The factory default transmitter ID is ‘1’. Loo

5Screen 1: Transmitters displays on the console screen. You should see the words: “RECEIVING FROM...” and “STATION NO.” followed by the transmitter ID

6This puts the transmitter in TEST mode. An LED indicator light flashes each time it transmits: • The LED immediately flashes once to show that the li

7The following factors should be considered whether your temperature probe is inside a radiation shield or not: • If placing the probe on the outside

8Mounting the Wireless Temperature StationMounting on a Pole1. While holding the shelter against the pole, place a U-bolt around the pole and through

9Mounting on a Vertical Surface1. With a 3/16" (5 mm) drill bit, drill two holes approximately 2" (50 mm) apart. Use a carpenter’s level to